Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
Text excerpt from page 120 (click to view)
1
2
3
4
A
11 12 13 14
Remove the three screws. Remove the PCB support. Remove the flexible cable and disconnect the connector. Remove the DVDM Assy.
15 16
Connect the two jig cables. Reattatch the three flexible cables(A ) and the one connector (A) from the Table Mechanism Section.
17 12
PCB Support
Remove the soldered joint pickup short point. Reattatch the clamper holder by reattatching the two screws.
18
Flexible cable
Cutting Pliers AF Assy DVD TRADE Assy
13
B
13 11
CN953
14
CN5105
15
CN5107
A
Jig cable (GGD1228)
13
C
11
CN911
11 15
DVDM Assy Jig cable (GGD1222) To DVDM To DVDM CN911 CN953
19 20
D
Insert the insulation sheet between the DVDM Assy and the chassis. Arrange the cables as shown in the photo below.
