|
Who's Online
There currently are 5894 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I am really satisfied. It was ceap, easy and quick. Te owner manual is a full service book. I got what I expected. Thx
;
The service was good but it just a little late for the download. It seems that it needs to clear the payment but the payment was settled by paypal. As far as my concern, it should be able to download after the confirmation of sold.
;
Great quality manual, fast service, excellent seller... Thanks !!!
;
Great manual and fast service. Download was possible after a few hours.
;
thanks a lot.
without the service manual my handycam was going to the trash.
good job, go on.
bye
5
6
7
8
Step 7: 1st DSP f
CN401 (Pin 20) RESET
j
CN401 (Pin 16)
For the following diagnosis, a digital oscilloscope must be used. SPICLK
A
Is the logic of RST_1 "H" ?
No
Check the output from the DIGITAL MOTHER Assy.
w
Yes R139
Is the clock signal output while the voltage at SPIDS_1 is "L"?
No
Check the output from the DIGITAL MOTHER Assy.
y
Yes R144
Is the logic of RST_1 "H" ? Yes
No
Check the resistors and patterns in the path.
Is the clock signal output while the voltage at SPIDS_1 is "L"?
No
Check the resistors and patterns in the path.
B
Is the logic of RST_1 maintained at "H"? (Does it fall to become "L" periodically?)
k
No It is likely a boot error. (It is very difficult to diagnose which peripheral part of the DSP is in failure.)
Yes CN401 (Pin 19) MOSI
g
Yes R134 REQ_1
Is the clock signal output while the voltage at SPIDS_1 is "L"?
No
Check the output from the DIGITAL MOTHER Assy.
C
z
Does the logic become "H" for a moment when the input stream is changed? No The 1st DSP is in failure. Replace it.
Yes R146
g
Yes CN401 (Pin 21)
Is the clock signal output while the voltage at SPIDS_1 is "L"?
No
Check the resistors and patterns in the path.
AA
Does the logic become "H" for a moment when the input stream is changed? No Check the resistors and patterns in the path.
Yes R142 MISO
h
Yes CN401 (Pin 17) SPIDS_1
Is the clock signal output while the voltage at SPIDS_1 is "L"?
D
No The 1st DSP is in failure. Replace it.
i
Does the logic become "L" for a moment when the input stream is changed? No Check the output from the DIGITAL MOTHER Assy.
Yes CN401 (Pin 18)
x
Yes R137
Is the clock signal output while the voltage at SPIDS_1 is "L"? Yes
No
Check the resistors and patterns in the path.
E
Does the logic become "L" for a moment when the input stream is changed? Yes
No
Check the resistors and patterns in the path.
It is very difficult to diagnose which part is in failure.
F
VSX-94TXH
5 6 7 8
35
|
|
|
> |
|