|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
;
Service Manual that I received was very helpful to me. Thank you.
1
2
3
4
Step 6: DIR A
A
Check that the S/PDIF signal is output. Check that changes by pulling out and inserting the digital input lines. IC601 (pin 1) IN1 (OPT: TV/SAT)
IC952 (pin 14) Do convert 3 V into 5 V for pin 6 input? Yes IC952 (pin 13) Do convert 3 V into 5 V for pin 7 input? Yes To Step 5
No Replace IC952.
Can No Check the DIGITAL INPUT Assy, observe the digital signal and parts and patterns in the path. ? (0 V <-> 4 V) Yes IC601 (pin 5) IN2 (OPT: CD-R/TAPE/MD)
B
No
Replace IC952.
Can observe the No Check the DIGITAL INPUT Assy, digital signal and parts and patterns in the path. ? (0 V <-> 4 V) Yes IC601 (pin 44) Can observe the digital signal ? Yes IN3 (COAX: DVD/LD)
Step 5: X'tal
IC802 (pin 2)
C
No
Check the parts and patterns in the path.
(1.65 V center, amplitude more than 0.2 Vp-p) IN4 (COAX: CD)
Is there a 24.576 MHz output? Yes IC802 (pin 7)
No Replace IC802 or X801.
IC601 (pin 42)
Can observe the No Check the parts and patterns digital signal in the path. ? (1.65 V center, amplitude more than 0.2 Vp-p) Yes No Check the path to pin 45 of IC801. Replace IC802. IC601 (pin 27) Is there a master clock output? No Check the path to pin 30 of IC601. Replace IC802. MCKO2 (Master clock) Check that the data and clock signals are output.
Is there a 24.576 MHz output? Yes
D
IC802 (pin 5)
Is there a 24.576 MHz output? Yes To Step 6
Is the No voltage of PDN IC601-pin 31 5 V? (0 V <-> 3.3 V) Check the other assy. (surrounding of the Yes microcomputer) No No Replace IC601.
IC601 (pin 24)
LRCK (LR clock)
E
Is there a LR clock output? Yes
No Replace IC601. (0 V <-> 3.3 V)
B
F
20
1 2
VSX-518-K
3 4
|
|
|
> |
|