There are currently no product reviews.
The manual was very accurate for the part that I was changing, I was able to order the correct part and had no issues with the replacement procedure. However, I was expecting to have more detailed repairs for the lower drive unit.
I needed the manual immediately and I got it immediately. I couldn't find this manual anywhere else on the net. The site was easy to traverse, and the price was very reasonable. I'll definitely be back for any future needs.
I received a good service manual, with good resolution. Improve the instructions for the purchase because they are not well understood.
For the rest, so good.
Very good documentation for the Grundig 2077 model (as well as similar 800/900/1000 series radios). The first two pages are a summary of reception specifications and output capability. The third page is the tuner dial indicator and dial cord routing diagram. the final ~5 pages are the schematics for the various models (including 2077). The scan quality of the schematics are good, adn can be easily read if zoomed in. The documents are in German, not English as stated. It would have been nice to have the tuning sequence and settings, and some trouble shooting materials... or component and wiring map.
Perfect like it was descriped, Perfect like it was descriped
There is no information to be shown in this chapter.
7. GENERAL INFORMATION
Â¶ GRILL ASSY SECTION
Remove the Grill Assy. Insert a screwdriver into the slit under the Grill Assy to pry open the front grill gradually and uniformly. Remove 3 (AC and Signal) connectors from the CONT ASSY .
3 3 A 4 5
Â¶ REAR COVER SECTION
Remove 6 screws (1) from the Rear Cover.
Â¶ JACK ASSY SECTION
Remove 6 screws (2) from the JACK Assy. Remove the A connector from the CONT Assy .
Â¶ SPEAKER SECTION
Remove the Rear Cover. Each speaker is attached to the Back board by 4 external screws (3). detach it, unfasten those screws. When attaching it, face its terminal upward.
Â¶ POWER ASSY SECTION
Remove the Rear Cover. Remove 6 screws (5) from the Back board. Remove the 6 connector from the POWER Assy .