There are currently no product reviews.
again you did a very good job. It was fast too. Photocopy are really readable and clear
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
Great copy of the manual, has all information required for servicing,
I work at an authorized service center and I can tell if a manual is as it should be. This one is. It may be a scan, but a very good one at that. The interesting part for me was the curcuit diagram which was scanned at high quality, making it as good as the original. I will definitely be back as a customer. I need not say this, but I will: the price was the best. Thank you owner-manuals.com .
2.2 PANEL FACILITIES
4 Crossover knob (CROSSOVER)
When using the subwoofer, set the upper frequency limit for the subwoofer (50 Hz to 200 Hz) so that it complements the output from your other speakers. When using the bass management features of an AV receiver, set to BYPASS ON in order to use the low-pass filter of the AV receiver for high quality sound.
5 Bypass switch (BYPASS)
When set to ON, the audio signal is routed directly to the woofer unit, bypassing the amplifierâs filter.
6 Phase switch (PHASE 0Âº /180Âº)
When set to 180Âº, the output phase becomes the reverse of the input signal, and when set to 0Âº, it is in the same phase as the input signal. â¢ Normally, the switch is set to 0Âº. But when the sound connection between the subwoofer and the left and right speakers sounds unnatural, try switching to 180Âº and set the switch in the position where the sound is natural. â¢ When using two or more subwoofers together, make sure that the phase switch of all of them are set to the same position.
1 Power Indicator (POWER ON)
Lights green when the power has been switched ON.
â¢ If you are planning on switching the unit OFF for a long period of time, make sure to check that the indicator light has gone out after switching OFF.
7 Line Level Input terminal (LINE LEVEL INPUT)
Connect to the SUBWOOFER PREOUT terminal of an amplifier or receiver, with a RCA plug cord.
8 Line Level Output terminal (LINE LEVEL OUTPUT)
Used for connecting other equipment through the amplifier. The signal output from this jack is not affected in any way by the settings of the various controls on the unit.
9 AC IN
POWER VOLUME CROSSOVER
MAX MIN 200 Hz 50 Hz
2 3 4 5 6
â¢ Connect the power cord to the powered subwoofer unitâs AC IN. â¢ Connect the power cord to a AC socket.
OUTPUT INPUT AC IN
7 8 9
2 Power switch (POWER)
Switches the subwoofer between ON and OFF.
3 Volume knob (VOLUME)
Sets the subwoofer volume. â¢ Turn the knob slowly from the MIN position. â¢ With this unit, the bass level can be independently set, so do not turn up the bass on the AV amplifier.