There are currently no product reviews.
Great manual and fast service. Download was possible after a few hours.
thanks a lot.
without the service manual my handycam was going to the trash.
good job, go on.
This service manual is a good copy of the original, complete and fully readable. It is really useful to repair my Tv set following its clear instructions.
Excellent quality. Easy process to download. No issues or problems at all - was exactly what I was looking for and needed. Great service.
I was having a hard time finding the problem with this Mackie 1604 unit. I didn't have a schematic. Went looking on the web and found your site and the price was more then reasonable. Ordered it and within the hour had the manual and within 15 minutes had the unit fixed. Best $4.99 I ever spent. Thank you.
USING THE DIGITAL TUNER (sold separately) TO WATCH DTV
TV/ CBL VCR DVD DTV /SAT /LD
Set the SYSTEM MODE to ON. (Refer to page 66.)
â¢ â¢ Monitor input will be fixed to INPUT 1 and the picture from the input source selected by the receiver displayed. To watch TV, switch the receiver input to where the monitorâs TV OUTPUT signal connects. Channels can be selected using the monitorâs remote control.
1 Switch the receiver to where the digital tunerâs signal connect. 2 Set the mode switch to TV/DTV on the monitorâs remote control. 3 Press the DTV button on the monitorâs remote control.
â¢ â¢ Switching the monitor to DTV mode makes it possible to view a high-quality 1080i picture. Each time the DTV button is pressed, the operating mode will switch between DTV and TV mode. To change the input source, first switch to TV mode and then use the receiver to switch the input source.
1 4 7
2 5 8 0
3 6 9
4 Use the monitorâs remote control to select the channel. 5 Use the receiver to adjust the volume or select surround settings.
PROJECTION MONITOR RECEIVER REMOTE CONTROL UNIT
NOTES: â¢ When SYSTEM MODE is turned ON and the system is connected to a non-Dolby Digital receiver, no DTV audio output will be produced, and SYSTEM MODE should accordingly be turned OFF at such times. â¢ Turning SYSTEM MODE ON will cause all monitor input to be input from INPUT 1, and SYSTEM MODE should accordingly be turned OFF when connected to RGB input.