|
Who's Online
There currently are 6001 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
The manual describes this product very good. It has the basic things to know and also a more detailed look. Very well made!
;
An excellent document to assist in the repair of my old personal tape player. It includes full circuit diagrams and physical layout drawings and full instructions on disassembly and fault finding.
Well worth the meagre price.
;
Very good conversation, Pretty fast Service, wood do it again,
Have paid by Paypal, so i got the Service Manual online after 15 Min.
Very helpfully.
Greeting from Germany,
Hans
;
Good-quality scans. Detailed description. I hope I can repair the machine.
;
High-quality scanning. Detailed description. Recommend for all technician. A+++
5
6
7
8
Note) This product has high voltage circuits inside, and the voltage will be kept for a while by big capacitors. So, before starting disassembly(especially removing the Buss Bars(CND3947)), make sure if the voltage of +VH and -VH become low enough after turning off the power supply(+B & ACC). If you want to discharge the capacitors faster, connect the resistors of same value in parallel with the original discharge resistors (R241 - R246).
A
- Removing the Amp Unit (Fig.3)
1
Remove the eight screws and then remove the four Buss Bars.
2 3 4 5
Remove the two screws. Remove the four screws.
B
Remove the seven screws.
Disconnect the Connector and then remove the Amp Unit.
C
Note) Removal of substrate while the Buss Bar being connected will deform the Buss Bar, failing to set up again. Buss Bar
1
1 5
1 1
1
3
1 4
1 4 4
1
3
3
4 4 4 4
D
3 2
2
Amp Unit
Fig.3 Note) Remove a screw for MODE SELECT only when switching over the mode selection.You do not have to remove this screw when removing the unit board. (Fig.4)
E
Screw for MODE SELECT Fig.4
F
PRS-D2000SPL/XU/UC
5 6 7 8
15
|
|
|
> |
|