There are currently no product reviews.
This is an excellent information source. Great quality and tons of info regarding technical service for the Technics SH8065.
5 stars on this manual since it is the complete version, not the half manual you find free for download all over the web. Good job.
Thank you very much you are helping me a lot with my preferred hobby!!! this manual of an old TV is going to be very helpful!!!!
You are very honest competent great job very clear and well done!!!!
An excellent service manual contains dismantling locations of components, electronic adjustments,worth the money.
Caracteristiques,circuit adjusment,notes on schematis diagram,it's a good service manual,to live well,thanks.
USING THE DIGITAL TUNER (sold separately) TO WATCH DTV
TV/ CBL VCR DVD DTV /SAT /LD
Set the SYSTEM MODE to ON. (Refer to page 66.)
â¢ â¢ Monitor input will be fixed to INPUT 1 and the picture from the input source selected by the receiver displayed. To watch TV, switch the receiver input to where the monitorâs TV OUTPUT signal connects. Channels can be selected using the monitorâs remote control.
1 Switch the receiver to where the digital tunerâs signal connect. 2 Set the mode switch to TV/DTV on the monitorâs remote control. 3 Press the DTV button on the monitorâs remote control.
â¢ â¢ Switching the monitor to DTV mode makes it possible to view a high-quality 1080i picture. Each time the DTV button is pressed, the operating mode will switch between DTV and TV mode. To change the input source, first switch to TV mode and then use the receiver to switch the input source.
1 4 7
2 5 8 0
3 6 9
4 Use the monitorâs remote control to select the channel. 5 Use the receiver to adjust the volume or select surround settings.
PROJECTION MONITOR RECEIVER REMOTE CONTROL UNIT
NOTES: â¢ When SYSTEM MODE is turned ON and the system is connected to a non-Dolby Digital receiver, no DTV audio output will be produced, and SYSTEM MODE should accordingly be turned OFF at such times. â¢ Turning SYSTEM MODE ON will cause all monitor input to be input from INPUT 1, and SYSTEM MODE should accordingly be turned OFF when connected to RGB input.