|
Who's Online
There currently are 6010 guests and 4 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
The purchased manual is an high-quality scan of the original JVC paper-based Service Manual. The Service Manual includes the Owner´s Manual, so you do not have to buy both of them.
;
It paid to find this Service Manual, couldn't find it anywhere else. Exactly what I wanted. Received within 24 hours.
;
Complete manual with clear schematic diagrams and printed circuit board layouts of two variants of the headset and the transmitter an old and a new version.
Also shows how the headset and the transmitter is opened and how transmitter and receivers can be adjusted and where to measure.
I had no problems to repair the headset using this service manual.
;
Excellent printing quality. A complete and very useful manual with all details.
;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
PRO-200, PRO-100
14 -3 Tint adjustment
Start 1st FAC
"Color bar"
(DOWN)
ADJUSTMENT OFFSET
Adjust the screen to optimum condition.
TINT
2
DVD COMPONENT VIDEO INPUT
DVD Player
� For the adjustment of 14 -2 and 14 -3. When it does not have the color bar generator with component video output. (However, make it finish the adjustment of composite video in advance.) 1. Prepare the DVD player with the component video output and the Video software. 2. Input the component signal to the DVD COMPONENT VIDEO INPUT of the TV, and input the composite signal to the VIDEO 1 INPUT. 3. Set the AV MEMORY of LD/DVD, VIDEO 1 to the STANDARD in the normal use mode (It does not enter the FACTORY ADJ mode.) 4. Playback the Video software. 5. Adjust the value of COLOR and TINT of PICTURE of MENU1 with seeing sometimes video of VIDEO 1 so that the video (color) of LD/DVD becomes the same as the video of VIDEO 1. 6. The adjustment is complete, read the value of COLOR and TINT in the MENU, and change it into the value in FACTORY in accordance with the following table. Example: In MENU �30 �15 +15 +30 MENU FACTORY 2Steps 2Steps 2Steps COLOR +17 +19 In FACTORY COLOR TINT 2Steps TINT �5 �10 7. Input the changed value to COLOR and TINT of the component offset in the FACTORY ADJ mode. (End)
14 -4 Contrast adjustment
Start 1st FAC
(DOWN)
"Color bar"
Adjust the screen to optimum condition.
3
"Normal video signal"
ADJUSTMENT OFFSET
CONTR
At the TP-BK of the B. CRT DRIVE assy, check that the signal is shaped as shown below A .
A Shapely waveform
saturated B Shapeless waveform
original page 158
58
|
|
|
> |
|