|
Who's Online
There currently are 5598 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
As Always you can find here manuals even of difficult TV scheme which are scan in almost perfect way.clear and fast!!!!!
Great work thanks!
;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
PDR-509
Code
Symptom
Contents of Error
Defects related to the recording laser power
Possible Cause
� Defective laser diode � Trouble in RF detection � Defective RFT RFB circuit � Recording power is not sufficient. � Improper soldering, pattern short � Trouble with power supply � Unable to read ATIP or subcode � Defective laser diode � Defective focus drive circuits � Defective pickup � Improper soldering � Pattern short � Trouble of power supply If any hardware trouble occurs before displaying A� or d�, the unit stops displaying a code other than these codes. Therefore, these service codes are generated only for troubles with the disc.
Checkpoints
IC201 (PA9007A) IC101 (AK8563) IC363 (TC7S04F) IC364 (TC7S14F)
C�
The unit stops before it enters REC/PAUSE mode.
� Dirty or cracked disc � The optimum recording power cannot be obtained. � Trouble in RF detection. Defective pickup � Unable to focus because of dirt or
F�
The unit stops during playback or recording.
crack on the inserted disc. � Unable to output the proper laser power
IC451 (M56788FP) IC401 (CXD2585Q)
A�
The unit stops in a recording-related operation, displaying "CHECK DISC."
� Unable to focus Stop during recording � The unit stops, being obstructed by a dirt or a crack on the disc.
d�
The unit stops in a recording related operation, displaying "CHECK DISC." The unit does not read the inserted disc, and stops.
The indication for * shows themechanism mode listed below. No.
0 1 2 3 4
Mechanism Mode
PLAY OPEN STOP � �
No.
5 6 7 8 9
Mechanism Mode
SETUP TOC READ � SEARCH REC/PAUSE
No.
A B C D E REC
Mechanism Mode
TOC REC OPC TOC CHECK PMA, ACTUAL PAUSE REC
71
|
|
|
> |
|