|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
;
This service Manual for my JVC AV29BF10EES is very helful. Everything is show in detailed diagrams!!!! If you need really good source of information for this type JVC you are on the right place. I am satisfied and very glad for this excellent book. Thank you.
;
Great service, great value like always!!!
Some of the writing is a bit blur but all is usable.
A+++++++++++++++++
;
Great service manua!
Always great value and fast service A++++++++++++++++++
;
Excellent Service manual, good quality scans, quick service and very good value. Well reccomended ! All good.
PDP-501MX, PDP-V501X
2.Removing the Front Protection Panel (Fig. 3, Fig. 4)
1) Remove all screws 2 and 4 inside the front case. Be careful not to remove screws B (two at the bottom) and screws C (three at the top) because they are used for securing the aluminum sash. 2) Remove all panel shields 1 and 3 and panel holders 2 and 4. 3) Remove and replace the front protection panel. 4) Attach the protection panel by attaching to the bottom left side first, and then attach the front case assembly in the reverse procedure of the above. When securing the front case to the unit, attach the two bosses D (one each on the two edges of the top) as a guide so that the boss at the center A passes through the hole on the rear case. Note) When attaching the panel shield and panel holder after replacing the protection panel, the panel shield may deform when tightening the screws 3 as shown in Fig. 4. If it deforms, untighten screws 3 slightly and tighten until just before it starts to bend.
3 3 2
Panel cushion 50V Panel cushion 50V Panel cushion 50H
4
Front protection panel 2 Shield gusket F Shield gusket D
2 2 1 2 1 2 2
3 3
3 C D
C
Panel cushion 50H
1 A
2 1
2 2
Shield gusket F Shield gusket C Shield gusket E
Shield gusket D
2 2 1 1
2 2 2 2 2 2 2 1 1 2 B
Shield gusket G
C D 3
Shield gusket B
3
B
4
Shield gusket H
3 3 3
Front case
3 3
Aluminum sash D Aluminum sash U
Fig. 3
77
|
|
|
> |
|