|
Who's Online
There currently are 5746 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I BOUGHT A PAIR OF INFINITY VINTAGE SPEAKERS THAT REQUIRED TO BE REPAIRED AND THE ELECTRONIC TECHNICIAN ASKED ME FOR THE SERVICE MANUAL.
I TRIED TO GET IT AT THE MANUFACTURER'S SITE WITH NO SUCCESS, SO I STARTED TO LOOK FOR IT IN THE WEB FOR A LONG TIME, UNTIL I FOUND THE SERVICE MANUAL IN THIS EXCELLENT SITE "OWNER'S MANUAL.COM".
NOW I HAVE MY SPEAKERS WORKING AND ENJOYING THE MUSIC I LIKE.
THANKS TO "OWNER`S MANUAL.COM" I RECOMMEND THIS SITE TO EVERYONE.
;
Very quick response. Very good and accurate print quality of the scanned document.
;
The service manual was very usable and clear enough to see the individual values of all of the components (unlike some of the service manuals I have gotten in the past from web sites similar to this one). The price was right and the information was greatly appreciated. It helped me with an otherwise very difficult repair. It was much needed and appreciated. A faster turn around on my order would be nice, but I understand the constraints on your staff's time. Thank you for your service.
;
Excellent manual. Helped me out with disassembling and troubleshooting my projector.
;
thanks you are the best.Very good detail, Quick service response. A useful service manual with all details.
1
2
3
4
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
A
1.1 GRILLE ASSY
The Grille Assy is secured to the baffle plate with two-sided tape and bosses. When removing the Grille Assy, if is necessary to wear cotton gloves.
tape. Press the bosses into the baffle plate and press the entire grille into position.
1.2 WOOFER(Disassembly)
The woofer is secured to the baffle plate with four screws from the inside. To remove the woofer, first remove the baffle plate.
Disassembly
Remove it from the under side. 1. Insert the tip of your gloved finger into the gap between theGrille Assy in front and the corner of the baffle plate so that the Grille Assy is slightly lifted.
B
Reasassembly
When reassembling the woofer, place it so that its + terminalis is facing downward. Tighten the screws to the baffle.
1.3 TWEETER(Disassembly)
The tweeter is secured to the baffle plate with two screws from the inside. To remove the tweeter, first remove the baffle plate.
Reasassembly
When reassembling the tweeter + terminal fces outside.
Network Assy(Caution)
2. Insert the gloved finger to the extent of the second joint into the gap between the cabinet and the Grille Assy. When removing the Network Assy, pull it out a little at a time from alternate sides, because it is seated tightly.
C
1
2 1
Input terminal
3. Alternately and gradually lift the left and right sides of the Grille Assy by about 5 cm, sliding gloved fingers along the cabinet. When lifting the Grille Assy, be sure to lift the left and right sides alternately, but not both sides simultaneously.
When reassembling it, apply a adhesive to the screws. Network ASSY
D
Note: Be careful not to bend the Grille Assy too far. Otherwise, it may be damaged. OK : Good example NG : Bad example
Baffle Assy(Caution)
Grille ASSY
When reassembling the cabinet and the baffle plate, secure the screws in the order shown in the figure below:
13 10 8 6 4 3 2
E
OK
Grille ASSY
12 11
9
7
5
1
NG
F
Reasassembly
Remove the old two-sided tape attached to the rear side of the Grille Assy and the front side of the Baffle, and adhere new twosided 2 PDP-S64
1 2 3 4
|
|
|
> |
|