|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Great manual very clear copied. You are making an incredible job. I appreciate a lot the rapidity and your efficiency. Thanks a lot
;
Good pdf of the service manual for this unit. Includes disassembly instructions, full schematics, board layouts, parts lists and diagnostic information. Some information is in the pdf twice (single pages, and split pages), but that could be how it was originally generated by panasonic, or perhaps the idea is to make it eaiser to put onto 8.5 x 11" pages.
Information was exactly what I needed. Delivery was overnight (less than 12 hours) and I was happy with the process.
;
5 STARS for FAST DELIVERY, BEST PRICES and QUALITY PRODUCT. Item was exactly as described with superb resolution. Will definitely source all my future requirements from this website. Thanks a lot owner-manual.com!
;
OEM manual provided all schematics, board layouts and component specs necessary to facilitate unit maintenance. All pages were clear and readable.
;
Good condition and quality. Hard to find anywhere in Internet, only on this site.
1
2
3
4
7. GENERAL INFORMATION
7.1 DIAGNOSIS
7.1.1 TROUBLESHOOTING
A
Image for the composite or S signal is not displayed
Image for the composite or S signal is not displayed No Is the function corresponding No Select the corresponding to selected signal input signal with the Input selector. selected? Yes
B
TV signal is not displayed on the screen. Yes Is the Input selector set to TV? Yes Is a signal output normally from the FE (U7501)? (18) Yes Has the signal arrived at IC8002? (63) 2 Yes Check around the FE and No check the communications between the FE and the microcomputer. No Check the communications between U7501 and IC8002. No Set the Input selector to TV.
Has the signal arrived at IC8002?
No Check the communication between the jack and
B
Yes
IC8002.
1
B
B
C
Which signal is not output, main or subsignal? Main signal Is a signal output from IC8002? (44) (47) 34 Yes
D
Subsignal
Check around IC8002 and No check the communications
No
B
between IC8002 and the microcomputer.
Is a signal output from IC8002? (56) (58) 56 Yes
B
No Check the communications between IC8002 and IC6255.
Has the signal arrived at IC6107? (52) (59) 78 Yes
A
No Check the communications between IC8002 and IC6107.
Has the signal arrived at IC6255? (52) (59) 9 10 Yes
A
Is the communication No Check around the IC that is between each IC on the found to have a failure in MR MAIN BOARD Assy and communication and the the microcomputer normal? microcomputer. Yes
E
Has the symptom been settled when the MR MAIN BOARD Assy is replaced? Yes
No The panel is defective.
Note:
Finishing troubleshooting � Diagnosis points
A B
F
MR MAIN BOARD ASSY AV BOARD ASSY
� For check the communication with the microcomputer, refer to the section 6.7 SERVICE FACTORY MODE. � The encircled numbers denote measuring point in the Waveforms for Troubleshooting.
178
1 2
PDP-R05U
3 4
|
|
|
> |
|