|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
;
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
;
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
;
Generally speaking good copy; a few pages too hard contrast...
Good service and communication.
Preparation
05
Preventing the flat screen TV from falling over
After installing the stand, be sure to take special care to ensure that the flat screen TV will not fall over and is stabilised to both the wall and rack.
(PDP-LX509A)
Stabilising on a table or rack
Stabilise the flat screen TV as shown in the diagram using the falling prevention metal fittings and screws supplied with the optional stand. Note � Before stabilising the flat screen TV on a stand or rack, make sure that the falling prevention metal fittings are attached to the stand. � To stabilise the flat screen TV on a table or rack, also use commercially available wood screws that have a nominal diameter of 4 mm and that are at least 20 mm long.
8 to 15 mm
20 mm min.
(PDP-LX609A)
Wood screw (commercially available, 4 mm x 20 mm min.)
8 to 15 mm
20 mm min.
Drill a hole in the middle at the rear of the tabletop panel before using a wood screw. Perform this work the same way on the left and right sides.
4 mm
Using a wall for stabilisation Wood screw (commercially available, 4 mm x 20 mm min.)
1 Attach falling prevention bolts (hooks) to the flat screen TV. 2 Use strong cords to stabilise it appropriately and firmly to a wall, pillar, or other sturdy element. Perform this work in the same way on the left and right sides. Use hooks, cords and fittings that are available on the market. Recommended hook: Nominal diameter 8 mm, length 12 mm to 18 mm
4 mm
12 mm to 18 mm 1. Hook
Drill a hole in the middle at the rear of the tabletop panel before using a wood screw. Perform this work the same way on the left and right sides.
2. Cord Fitting
M8
15
En
|
|
|
> |
|