|
Who's Online
There currently are 6029 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Thank you very much. the Instruction corresponds to my expectations. Sent it in time. I don't regret that paid money.
;
Good quality. Quick service. I recommend to everyone.
;
Very good quality scan of the document. I am very pleased with what I got.
;
PDF Contains
Technical Data, Mechanical data, Detailed Circuit diagram with components value, PCB layout. Actual PCBs Print. Component List, Spare parts code list and Input output detail. It cover LBB1211, LBB1212, LBB1213, LBB1216, LBB1217.
It is the actual Service Manual for SQ10
;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
CONNECTIONS
CONNECTING THE SPEAKER CORDS
1 Strip off the vinyl covering and twist the tip of the wire core. 2 Loosen the knob and insert the wire core into the terminal hole. 3 Tighten the knob to fix the wire core in place.
3/8 inch (10mm)
2 1
\
3
Twist the wire core.
The speaker terminals also accept single banana plugs. (Refer to speaker manual for details.) 1 Tighten the knob to the closed position. 2 Insert the banana plug.
1 2
NOTES: � Do not allow any of the cord conductors to protrude from the terminals or touch any other conductors. Malfunctioning or breakdown may occur when conductors come into contact with each other. � If the knobs have not been turned and fixed firmly in a closed position, there may be interruptions in sound and poor sound quality. Speaker Impedance The speakers connected to the speaker terminals should have a rated impedance in the range of 4 � to 16 �.
CONNECTING UP FOR REMOTE CONTROL USE
If you are using a Pioneer amplifier or receiver with the � mark (for example, the VSX-39TX), you can control this unit with the remote controller that came with the amplifier/receiver. Once connected, this unit will switch on with the rest of your system. If the two amps are not on or off in unison, use the power button on the main unit to put them in the same state. Then you will be able to control them both with the remote control. To connect directly, use the supplied remote control cord to connect the control out terminal of the amplifier/receiver to the control in terminal of this unit (see Fig. A). If your system includes one or more � compatible units, you can daisy-chain them from your amplifier/receiver using commercially available monoral mini-plug cords, with the M-10X at the end of the chain (see Fig. B).
Fig. A
M-10X
CONTROL
IN
Pioneer amplifier/ receiver with the � mark
CONTROL OUT
Remote control unit
Fig. B
CD player etc. Amplifier/Receiver
M-10X
CONTROL
IN
NOTES: � Make sure that at least one set of analog terminals is connected through each component in the chain (as you did with the remote control cord(s)) to the amplifier when controlling other components. � When operating another component using a remote control, it must be pointed at the amplifier/receiver, and not at the component. � Only Pioneer products with the � mark can be connected in this manner.
CONTROL OUT IN
CONTROL OUT
Remote control unit
7
En
|
|
|
> |
|