|
|
|
Who's Online
There currently are 5504 guests and
5 members online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual is great help for me, i'm happy to have it,thanks
 ;
Very pleased with manual except that a few more details in the drawings might make the job (not yet done, tut-tut) easier. Should be adequate though. Actually I didn't have to pay for this anyway as I was given credit for another item that wasn't quite complete. Good service, then.
;
Very useful manuals, somewhere graphics not very clear!
;
A great manual; it contained all the information I required and allowed me to restore the receiver to full working condition!
;
Very good expirience with owner-manuals.com.
5 Stars; In future if necessary, i´ll download manuals on this site.
5
6
7
8
A
For Diagnosis
For PRO-141FD
Terminal panel ELT
1 2
Remove the two screws. (BPZ30P080FTB) (KRP-600M only) Remove the two hexagon headed screws. (ABA1382)
2
�2
Terminal panel MTR
For KRP-600M
2
�2
1
1
B
Support bracket MTR
3 4 5
Remove the four screws. (PMB30P060FNI) Temporarily tighten one of the screws that was removed in Step 3. Disconnect the flexible cable from the MAIN Assy.
4
3
3
5 3
MAIN Assy I/O Assy
C
3
6 7
Remove all the cables that are connected to the I/O Assy from their clamps. Remove the cables that are connected to the CN1201 connector from their clamps.
6
6 A 6
CN1201
7 7
D
Note: In a case where the ambient temperature is 35 °C or less You can reverse the I/O Assy in Step 8 without removing the cables from their clamps in Step 7 above, if you detach the CN1201 connector from the I/O Assy and remove the cables connected to the connector from Clamp A.
8
Detach the I/O Assy with support bracket MTR attached. Reverse the I/O Assy in the direction shown in the photo below:
9
Hook support bracket MTR onto the temporarily tightened screw then reconnect the flexible cable to the MAIN Assy.
9
E
8
I/O Assy
Support bracket MTR
I/O Assy
F
PRO-141FD
5 6 7 8
181
|
|
|
> |
|
