This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
Irrespectively of this manual exist only germany language, it's useful - although i need some additional task to translate: My english is bad, but usable - but i really dont speak germany. :)
Text excerpt from page 31 (click to view)
CRD3539A_Eng
9/21/01 4:44 PM
Page 31
Section
Audio Adjustments
07
Equalizer curve fine adjustment
You can adjust the center frequency and the Q factor (curve characteristics) of each currently selected curve band (EQ-LOW/EQ-MID/EQHIGH).
Adjusting bass
English Español Deutsch Français Italiano Nederlands
You can adjust the cut-off frequency and the bass level. In FRT1 mode, bass adjustment affects only the rear output: front output cannot be adjusted. 1 Press AUDIO to select BASS. Press AUDIO until BASS appears in the display.
Level (dB)
Q=2N Q=2W Center frequency Frequency (Hz)
2 Select the desired frequency with 2/3. Press 2 or 3 until the desired frequency appears in the display. 40�63�100�160 (Hz) 3 Press 5 or � to adjust the bass level. Each press of 5 or � increases or decreases the bass level. +6 � �6 displayed as the level is increased or decreased.
1 Press AUDIO and hold until frequency and the Q factor (e.g., F-80 Q-1W) appears in the display. 2 Press AUDIO to select the desired band for adjustment. Press AUDIO repeatedly to switch between the following bands: EQ-LOW (low)�EQ-MID (mid)�EQ-HIGH (high) 3 Press 2/3 to select the desired frequency. Press 2 or 3 until the desired frequency appears in the display. LOW: 40�80�100�160 (Hz) MID: 200�500�1K�2K (Hz) HIGH: 3K�8K�10K�12K (Hz) 4 Press 5/� to select the desired Q factor. Press 5 or � until the desired Q factor appears in the display.
2N�1N�1W�2W
Note � If you make adjustments when a curve other than CUSTOM2 is selected, CUSTOM1 curve is updated.