|
Who's Online
There currently are 5958 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
;
I PURHASED THIS PRODUCT BECAUSE I WAS HAVING PROBLEMS WITH MY CDR20 HARMAN KARDON RECORDER. WHICH I PURCHASED NEW 12 YEARS AGO. AFTER REVIEWING THE MANUAL, I WAS ABLE TO ADJUST THE TENSIONER IN THE SYSTEM. WORKS LIKE A CHAMP!.
SAVED ME AT LEAST 100.00 WHICH WAS WHAT A SERVICE REPAIR STATION WANTED. GREAT MANUAL EASY TO READ. SPECIALLY AFTER I PRINTED THE PAGES WHICH DEALT WITH MY RECORDER. THANKS A LOT!!!!!!!!
;
You can fully trust on this one!
All the schematics are very crear an in one piece per page
;
I have never bought a service manual which is as competely readable as this althogh it was a scanned pdf. Thank you for this succesful manual also cheaper than other sites.
;
Thanks for a very good and readable servicemanual. Just what I needed as a "dinosaur technician". I really recommmend this site and will come back.
Åsbjörn
HTP702-SW, HTP202/302-SW
6. PANEL FACILITIES
REAR SECTION
4 3 2 1
1 POWER indicator
Illuminates RED when the power is being supplied.
LINE LEVEL
IN OUT MIN
2 Subwoofer LEVEL knob
LEVEL
POWER
MAX
Volume of subwoofer is adjusted with this knob. Turn this knob clockwise to raise the level. ÷ Starting with �MIN�, turn this knob and raise the volume slowly. If the unit is turned on with the volume set too high, it could cause hearing and/or speaker damage. Do not turn the volume up excessively high. The low frequency sound is apt to be raised too high since it is less disturbing and harder to detect than high frequencies. Caution must be taken here since the amplifier and speaker of the HTP702-SW, HTP202/302-SW will be clipped when the output of the amplifier or receiver is increased with the subwoofer level set to �MAX�.
AC120V 60HZ 60W
3 Subwoofer input terminal (LINE LEVEL INPUT)
Connect SUBWOOFER OUTPUT terminal of the receiver to this terminal with the accessory RCA cord. If the output of the receiver connected to this unit is high or if the output has a low range boosted by the Bass control, Bass boost, or other means, there may be some sound distortion even if the level of the unit is lowered. In this case, lower the output level (Volume, Bass control, Bass boost) on the receiver side.
4 Subwoofer output terminal (LINE LEVEL OUTPUT)
Used for connecting an additional subwoofer to the system. Connect this terminal to the SUBWOOFER INPUT terminal of another subwoofer.
9
|
|
|
> |
|