|
Who's Online
There currently are 5463 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
GM-X642,X542
22
Gain Control Power Indicator
If sound level is too low, even The power indicator lights when the volume of the car stereo used along power is switched on. with this power amplifier is turned up, turn gain control on front of the power amplifier clockwise. If the sound distorts when the volume is turned up,
BFC (Beat Frequency Control) Switch turn the gain control counter-clockwise.
� When using with an RCA equipped car
stereo (standard output of 500 mV), set to If you hear a beat while listening to an the NORMAL position. When using MW/LW broadcast with your car stereo, an RCA equipped Pioneer car stereo with change the BFC switch using a small max. output of 4 V or more, adjust level to standard tip screwdriver. match the car stereo output level.
� If you hear too much noise when using the
speaker input terminals, turn the gain control counter-clockwise.
Bass Boost Level Control
LPF (Low-Pass Filter)/HPF (High-Pass Filter) Select Switch
Set LPF/HPF select switch as follows according the type of level around 60 Hz from 0 to 18 dB.
Bass Boost Level Control can boost the
� Bass Boost Level Control can be adjusted that is connected to speaker output connector and the car
only when the LPF/HPF select switch is stereo system: set to a position other than HPF.
LPF/HPF Select Audio frequency range Speaker Remarks Switch to be output Type
LPF (left) Very Low Frequency range Subwoofer Connect a subwoofer. OFF (center) Full range HPF (right) Low Frequency Full range Use if you want to cut the High Frequency very low frequency range because it is not necessary for the speakers you are using.
|
|
|
> |
|