|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
GM-X354
18
up, turn these controls clockwise. If standard tip screwdriver. (GM-X354/X1R/EW,ES) same position.
Setting the Unit
Gain Control Power Indicator
Adjusting gain controls A and B will The power indicator lights when the help match output of the car stereo power is switched on. to the Pioneer amplifier. Normally, set gain controls to the �NORMAL� position. If the output is low, even when volume of the car stereo is turned
BFC (Beat Frequency Control) Switch
there is distortion when the volume of If you hear a beat while listening to an the car stereo is turned up, turn these MW/LW broadcast with your car stereo, controls counter-clockwise. change the BFC switch using a small
� If you only use one input plug, set the gain
controls for speaker outputs A and B to the
� When using with an RCA equipped car
stereo (standard output of 500 mV), set to the NORMAL position. When using with an RCA equipped Pioneer car stereo with max. output of 4 V or more, adjust level to match the car stereo output level.
� If you hear too much noise when using the
speaker input terminals, turn the gain control counter-clockwise.
LPF (Low-Pass Filter)/HPF (High-Pass Filter) Select Switch
to speaker output connector and the car stereo system: LPF/HPF Select Audio frequency range Speaker Remarks Switch to be output Type
LPF (Left) Very Low Frequency range Subwoofer Connect a subwoofer. OFF (Center) Full range HPF (Right) Low Frequency Full range Use if you want to cut the High Frequency very low frequency range because it is not necessary for the speakers you are using.
Input Select Switch Set LPF/HPF select switch as follows according to the type of speaker that is connected
For two-channel input, slide this switch to the left. For four-channel input, slide this switch to the right.
|
|
|
> |
|