|
Who's Online
There currently are 5878 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Hard to find manual was ready the next day. Scans were very legible (including schematics). All the essential parts of the service manual were present (adjustment procedure, schematics, and parts list). It would have been nice if the rest of the manual was included (disassembly procedure, theory of operation, etc.).
;
The Service Manual for the Kenwood KR-V55R provided by owner-manuals.com was as described/advertised. The contents provided the necessary information to effect a diagnosis of the unit. The schematics above all else was instrumental in tracing the the signal flow from component to component.
;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
;
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
D
C
E
B
A
F
24
8. OPERATIONS
1
1
Gain Control Power Indicator
Adjusting the gain controls A and B The power indicator lights when the EW, ES models will help match output of the car power is switched on. stereo to the Pioneer amplifier. Normally, set gain controls to the �NORMAL� position. If the output is If you hear a beat while listening to an MW/LW broadcast with your car stereo, change the BFC switch using a small standard tip screwdriver.
BFC (Beat Frequency Control) Switch
low, even when volume of the car stereo is turned up, turn these controls clockwise. If there is distortion when volume of the car stereo is turned up, turn these controls counter-clockwise.
2
2
� If you only use one input plug, set the gain
controls for speaker outputs A and B to the same position.
� When using with an RCA equipped car
GM-6000F/X1R/EW
stereo (standard output of 500 mV), set to the NORMAL position. When using with an RCA equipped Pioneer car stereo with max. output of 4 V or more, adjust level to match the car stereo output level.
3
3
Input Select Switch
Set LPF/HPF select switch as follows according to the type of speaker that is connected
LPF (Low-Pass Filter)/HPF (High-Pass Filter) Select Switch
For two-channel input, slide this switch to speaker output connector and the car stereo system: to the left. For four-channel input, slide this switch to the right.
LPF/HPF Select Audio frequency range Speaker Remarks Switch to be output Type
LPF (Left) * � 40 to 120 Hz Subwoofer Connect a subwoofer. OFF (Center) Full range HPF (Right) * 40 120 Hz � Full range Use if you want to cut the 4 very low frequency range* If the LPF/HPF select switch is set to because it is not necessary LPF or HPF, you can select a cut off for the speakers you are frequency from 40 to 120 Hz. using. * See the �Cut Off Frequency Control� section.
Cut Off Frequency Control
4
|
|
|
> |
|