|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
helpful manual.good service.Quick response.will use again
 ;
Speedy confirmation to my order , with elaborate instructions .
Item Email , received immediately as desired by me.
A Pleasant & Satisfying Transaction.
;
I was searching for this manual at last i got it from this web
;
What can i say but i would have been lost without your support.
Thank You!
;
Très satisfait ! envoi rapide, Grand catalogue disponible. Many thanks !
06
Recording Setting the picture quality/ recording time
DVD (VR) DVD (Video) DVD+R DVD+RW DVD-RAM HDD
� SLP (Super Long Play) � Lower quality than EP, but gives about eight hours of recording time on a DVD disc. � SEP (Super Extended Play) � Lowest video quality but gives about ten hours of recording time on a DVD disc. � MN1 to MN32/LPCM1/XP+2 � Manual/ Linear PCM/XP+ (available only when manual recording is on). The setting is indicated in the front panel display, and shown on-screen together with the recording time for a blank recordable disc. If a recordable disc is loaded, the approximate remaining recording time for that disc is also shown. (Note that if the On Screen Display setting (see On Screen Display on page 128) is Off then this information is not displayed.)
Before starting a recording, you will usually want to set the picture quality/recording time. There are six standard settings available, which allow you to choose a balance between picture quality and recording time. When Manual Recording is set to On (see Manual Recording on page 123), a further option will be available (MN1 to MN32, LPCM, or XP+ (a super-high quality HDD recording mode that features a transfer rate of around 15 Mbps) depending on what you set). When recording to DVD, MN32 is the highest recording quality available. If you select XP+, the recording mode will automatically revert to MN32. When recording to DVD+R/+RW, SLP is the longest recording time available. If you select SEP or MN1 to MN3, the recording mode will automatically revert to SLP. � Press repeatedly to select the recording quality. � XP � High quality setting, gives about one hour of recording time on a DVD disc. � SP (Standard Play) � Default quality, used for most applications, gives about two hours of recording time on a DVD. � LP (Long Play) � Lower video quality than SP, but doubles the recording time on a DVD to about four hours. � EP (Extended Play) � Lower quality than LP, but gives about six hours of recording time on a DVD disc.
REC MODE
Basic recording from the TV
DVD (VR) DVD (Video) DVD+R DVD+RW DVD-RAM HDD
Basic recording from the TV involves just setting the channel to record, choosing whether to record to the HDD or a DVD and selecting the recording quality. 1 Select the HDD or DVD for recording. � If you�re recording to DVD, load a recordable disc (if you load a new blank DVD-RW or DVD+RW disc, the recorder takes a short while to initialize the disc). � If you want to record a VR mode DVD-R or a Video mode DVD-RW, you must initialize it before proceeding (see Initializing recordable DVD discs on page 54). 2 Press to switch between D.TV (digital) and A.TV (analog).
A.TV/D.TV HDD DVD
44
En
Note 1 Audio is recorded in 16-bit Linear PCM format, video is recorded at XP quality. When recording a bilingual broadcast, select which audio channel to record (see Bilingual Recording on page 121). 2 Applicable only to HDD recording. (If this setting is used when recording to DVD, MN32 is used.) When copied to DVD, XP+ recordings are always copied in real time.
|
|
|
> |
|
