|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Wonderful job clear. Qick fantastic. These people are really good. If even a problem arise they are wonderful assisting you. These scheme is so net despite this is a very old TV. Thank you for everything!!!!!!!!
;
Detailed schematic diagram, manual for professionals
;
Good service manual,exploded view,adjusment and test point locations,head alignment,mechanical checks and adjusments,all perfect.
;
Block diagram,play rec block diagram,adjusments, it's a very good well done repair manual.
;
Very clear copy of the philips service manual. Fast delivery. Thank you very much
5
6
7
8
7.1.10 DISASSEMBLY
Note: For performing the diagnosis shown below, the following jig cables for service are required: � GGD1330 �2
A
Diagnosis of the PCBs
Procedures ; SCRB Assy : ¥ � ø � � JCKB Assy : ¥ � ø � � � [ DVDM Assy : ¥ � ø � �
1 Bonnet and Tray Panel
1 2 3 4 5 6
Remove the Bonnet by removing the five screws. Press the power. STANDBY/ON button to turn on the
B
26
Press the 0 button to open the tray. Remove the tray panel. Press the 0 button to close the tray. Press the power. STANDBY/ON button to turn off the
4 3 5
Tray Panel Tray
C
35
How to open the Tray when the power cannot be on
Insert a screwdriver (small) into the slit located at the bottom of the unit, and slide the projection of the drive gear in the loading mecha. assy in the direction of the arrow, as indicated in the photo. If the tray pops out a little, fully pull it out by a hand.
D
Screwdriver (small) Projection
Slit Drive Gear Loading Mecha.Assy
E
Tray open
Screwdriver (small)
F
DV-565A-S
5 6 7 8
69
|
|
|
> |
|