|
Who's Online
There currently are 5734 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
The service manual is as described and received the link to the download sooner than expected. Great service, quality product. This site is a big help in the electronics repair business.
;
Il service manual molto accurato. Rapidi nella risposta
;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Quick service response. A useful and very rare service manual with all details. I recomend this service.
;
I ordered this manual sometime in the afternoon and I received it on my e-mail the same evening.
This is a fantastically good and properly scanned copy of the original manual. All pages are of the same scale and they overlap each other. It means that you can print the manual and easily make it as a convenient paper manual.
The content of the manual is fantastic. Alignment descriptions, PCB layouts and elementary diagrams are explicit and precise. I immediately found what I was looking for. Thanks to this manual and Owner-Manuals.com my amplifier is alive again. Many thanx indded!
DRM-7000, DRM-AF751, DRM-AL751, DRM-AH721, DRM-PW701
Rear Door
1
To manually open the Rear Door, insert a thin rod, such as a smalldiameter screwdriver, diagonally down approx. 50 mm through the hole at the lower side of the rear door. Press it down as shown in the illustration. Then the Rear Door can be manually opened.
3
2
Reader Drive Unit
2 3
Rear Door
PL Lock Lever � The reader drive can be installed in any slot. (You can install as many optional reader drives as there are slots available.)
Removing the PL Upper Cover of the Drive Unit
1
The PL Upper Cover is fixed with Claws at the front and with screws at the rear. To remove the PL Upper Cover, proceed as follows. Failure to do so may damage the claws.
2
Thin rod, such as a smalldiameter screwdriver
5
Reader Drive Unit
PL Upper Cover While pressing the PL lock lever toward RELEASE, slide the PL Upper Cover backward. (It will stop after sliding approx. 1 cm backward.) Claws (both sides)
4
�4
PL Upper Cover
7
Claw
1
�3
Remove three connectors.
6
Press and bend the front part of the PL Upper Cover from the left and right sides to unhook the claws, then lift up the cover. (Do NOT try to lift up the cover forcibly with the claws unhooked. This may damage the claws and make it impossible to reattach the cover.)
� When reattaching the cover, reverse the above procedures. (Place the cover approx. 1 cm backward and hook the claws, then slide the cover forward.) � Observe the driver unit from the rear to check that the claws are firmly engaged.
139
|
|
|
> |
|