This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
Text excerpt from page 147 (click to view)
5
6
7
8
A
In a case when no image from any input appears
� Reset discharge is occurred. � Mask is displayed. � DSD is not displayed. YES Examination of the MAIN board YES Is the voltage at Pin 51 of IC8501 3.3 V DC? NO Disconnect the cable from the PN1 connector. Check if 3.3V DC is output from Pin 1 of PN1. YES YES Waveform 33 Failure in the MAIN PWB NO Failure in the power supply unit, or PN1 cable broken
B
NO
Diagnosis of Panel Module
Is a CLK signal input to Pin 12 of IC8501? And are sync signals input to Pins 55 and 57? Is a DE signal input to Pin 58?
YES
Failure in the IC8501
C
NO Is the voltage at Pin 1 of PN2 connector 2.5 V DC? NO Disconnect the cable from the PN2 connector. Check if 2.5V DC is output from Pin 1 of PN2. YES YES Is the voltage at Pin 4 of IC8002 1.5 V DC? YES Is the voltage at Pin 5 of IC8003 1.5 V DC? YES NO Failure in the IC8003 NO Failure in the MAIN PWB NO Failure in the power supply unit, or PN2 cable broken
Failure in the IC8002
D
Waveform 34 NO Failure in the X8001
Is a CLK signal input to Pin 3 of X8001? YES of X8002? YES Failure in the MAIN PWB