|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I've been looking for a copy of the original user/owner manual. Just what the doctor ordered, thank you.
;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
Section
11
Audio Adjustments
# If you set the slope to 0 dB/oct. (Pass), the audio signal bypasses the filter, so the filter does not have an effect.
�12� �6�Pass (0) (dB/oct.)
3 Turn MULTI-CONTROL to select Rear HPF FREQ. Rear HPF FREQ. appears in the display. 4 Push MULTI-CONTROL left or right to select cut-off frequency. Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order: 50�63�80�100�125�160�200 (Hz) Only frequencies higher than those in the selected range are output from the rear speakers. 5 Push MULTI-CONTROL up or down to adjust the output level of the rear speakers. Each time MULTI-CONTROL is pushed up or down, the level of the rear speakers increases or decreases. 0 to �24 is displayed as the level is increased or decreased.
3 Turn MULTI-CONTROL to select Front HPF FREQ. Front HPF FREQ. appears in the display. 4 Push MULTI-CONTROL left or right to select cut-off frequency. Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order: 50�63�80�100�125�160�200 (Hz) Only frequencies higher than those in the selected range are output from the front speakers. 5 Push MULTI-CONTROL up or down to adjust the output level of the front speakers. Each time MULTI-CONTROL is pushed up or down, the level of the front speakers increases or decreases. 0 to �24 is displayed as the level is increased or decreased.
Using the auto-equalizer
The auto-equalizer is the equalizer curve created by auto TA and EQ (refer to Auto TA and EQ (auto-time alignment and auto-equalizing) on page 56). You can turn the auto-equalizer on or off. 1 Use MULTI-CONTROL to select Auto EQ. Auto EQ appears in the display.
# Please set Auto EQ appears. This indicates that you cannot turn the auto-equalizer on if auto TA and EQ has not been carried out.
Setting the high pass filter for rear speakers
1 Use MULTI-CONTROL to select Rear HPF. Rear HPF appears in the display. 2 Push MULTI-CONTROL left or right to select slope. Each time MULTI-CONTROL is pushed left or right, slopes are selected in the following order: �12� �6�Pass (0) (dB/oct.)
2 Press MULTI-CONTROL to turn the autoequalizer on. ON appears in the display.
# To turn auto-equalizer off, press MULTI-CONTROL again.
# If you set the slope to 0 dB/oct. (Pass), the audio signal bypasses the filter, so the filter does not have an effect.
52
En
|
|
|
> |
|
