Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
Text excerpt from page 59 (click to view)
5
6
7
8
7. GENERAL INFORMATION
7.1 DIAGNOSIS 7.1.1 DISASSEMBLY
- Removing the Case (not shown) 1. Remove the Case.
A
- Removing the CD Mechanism Module (Fig.1)
CD Mechanism Module
B
1
Remove the four screws.
Disconnect the connector and then remove the CD Mechanism Module.
1 1
- Removing the Grille Assy (Fig.1)
2
Remove the two screws and then remove the Grille Assy.
C
1 2 1 2
Grille Assy
Fig.1 - Removing the Tuner Amp Unit (Fig.2)
D
1 2 3 4
Remove the screw.
2
2 2
Remove the three screws.
Straight the tabs at three locations indicated. Remove the screw and then remove the Tuner Amp Unit.