|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
01
Getting ready
Caring for the remote
� Do not drop the remote. � Do not get the remote wet. � Do not use or store the remote in the following locations: In direct sunlight Near hot objects Areas with high humidity
Remote operation range
30° 30°
7m
� Do not mix new and used batteries. Only add all new batteries. � Do not mix battery brands. Different battery brands may have different voltages even if the same size. � When not planning to use the remote for a long period of time (over one month), remove the batteries to prevent battery fluid leaks inside the remote. If a battery leak occurs inside the remote, discard the old batteries, wipe out the liquid from the case, and add new batteries. � The Pioneer batteries supplied with the remote do not contain heavy metals, such as mercury, nickel, or cadmium. In many countries, however, the disposal of batteries with household waste is not allowed. Be sure to comply with local regulations when disposing of batteries. � The remote�s TV preset code setting will only last for about one minute without batteries, so to prevent the inconvenience of losing the stored settings, have ready a fresh set of new batteries and add them immediately after removing the old batteries. However, if the remote�s buttons are pressed while the batteries are removed, the brand code setting will be deleted. Please be careful not to press the buttons while replacing the batteries.
� If an object is blocking the path between the remote and the DTR signal sensor the unit might not respond to the remote commands. If this happens, remove the obstacle or change your position. � As the batteries weaken, the range of the remote becomes shorter. If the operation range is too short for your preference, replace the batteries.
8
|
|
|
> |
|