It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
Nice pdf file of the manual sent promptly. Thanks.
Text excerpt from page 31 (click to view)
CT-W208R
7. GENERAL INFORMATION
7.1 DIAGNOSIS
7.1.1 POWER ON SEQUENCE
� POWER/ON key is pressed. � Power on information with the sytem bus.
Note : Pin No. shows the Pin No. of µ-COM PD5351A.
Go to Power ON
Perform the mechanism initialization every time it power on. (When the AC outlet is pulled out while raising up the Head Base or the gear comes off, perform the initialization every time because the normal movement can't be done.)
200mS WAIT Check that the mecha. is stop condition (port Pin 14 and 20 = L) Is MODE SW OFF ? No MOTOR ON SOL 50mS ON (port Pin 53 and 55 ) (port Pin 54 and 56 ) No 150mS WAIT Is MODE SW OFF ? Yes Is it fifth times ? No No Is MODE SW OFF ? Yes 300mS WAIT Yes :ERROR Yes
500mS WAIT
MOTOR ON
ERROR
Is it second times ? Yes :Give up
No
MOTOR OFF
(port Pin 54 and 56 )
Initialize end Deck motor off (port Pin 54 and 56 = L)