|
Who's Online
There currently are 6033 guests and 2 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Je suis audiophile belge, électronicien et créateur d'enceintes acoustiques.
J'ai apprécié la qualité des documents fournis. Ils sont très lisibles, ils peuvent être agrandis sans problème et ils sont complets. Pour moi, c'est parfait. Pour cette qualité, je suis d'accord de payer. Et le système de paiement et d'envoi est simple. Merci, continuez comme cela.
Frédéric
;
The cover page was a little scary, very dark but readable. The remainder of the document was better copy and easily readable. Why would I give 5 Stars? (1) PRICE, (2) AUTHENTICITY, It was the real deal, filled with service information, including the specific information I required. (3) PRIVACY, I didn't start to get slammed with spam. (4) EASY TRANSACTION. Painless. (5) COMPLETE, I have found several manuals here, that I could find nowhere else. (6) I will be a repeat customer!
;
Well done!!! I found what I need to have, indeed!
Furthermore, due to my hobby is repairing vintage equipments, I added this web site in my desk toolbar because I have in mind to search further service manuals. Thanks a lot www.owner-manuals.com !
Regards, Maurizio
;
Again very good service manual, this time very fast download. AAAAA+
;
Ckear manual, well reproduced with plenty of overlap on critical pages.
CT-L5
6. ADJUSTMENT
For adjustment, use the CD RECEIVER (XC-L5).
6.1 Test Mode
There are two test mode: test mode 1 for execution of special operations and test mode 2 with LINE MUTE operation in the same way as for the deck by itself.
REAR
6.1.1 Test Mode 1
7 How to enter into Test Mode 1
In case of system operation ........
Receive �A15F� (bus data 1C5F) with the remote control or switch on the power with the TEST MODE JP [W101 (GNDD) and W103 (TEST)] of the MAIN UNIT short-circuited (pin 44 of the microcomputer connected to GND). (Refer to Fig. 6-1.)
+5.6V �10V +10V
B
CN2601
A
In case of single operation ........
Connect part A of the MAIN UNIT [W107,W113 (GNDA), W112 (GNDD) and chassis (KN2001)], short-circuit the TEST MODE JP [W101 GNDD) and W103 (TEST)] (pin 44 of the microcomputer connected to GND), and supply DC power to part B [TC+ (10 V), TC- (-10 V) and V+5.6 (+5.6 V) of CN2601]. (Refer to Fig. 6-1.)
TEST MODE W101 W103
Short point
CN2601 Pin 7 ...... +5.6V Pin 9 ...... �10V Pin10 ...... GND Pin11 ...... +10V
MAIN UNIT
When test mode is entered, �TEST3� is displayed and the �PLAY� and �REC� LEDs flash.
Fig. 6�1
7 Operation of test mode 1
(1) When the power is switched on, cassette mechanism switch check mode is entered and the CD RECEIVER (XC-L5) on the displays the following. 1 FUNCTION is set to AUX. 2 FWD recording is performed for 4 sec. 3 REV recording is performed for 4 sec. 4 FWD playback is performed for 4 sec. (Function becomes TAPE), and the unit stops. LINE MUTE opens in REC condition. (3) The keys �PLAY�, �FF�, �RWD� and �STOP� operate normally, and return to cassette mechanism switch check mode is made with the �OPEN/CLOSE� key. (4) �DOLBY� ON/OFF check mode is made with the �ASES� key. (5) When abnormal operation is detected, the corresponding code will be displayed on the
REV REC SW
ON: REV recording OFF: possible R Impossible �
FWD REC SW
ON: FWD recording possible F OFF: Impossible �
HALF SW
ON: Tape present OFF: Absent H �
Error Code
TAPE TYPE
NORMAL CrO2 (TYPE I) (TYPE II) 1 2
(2) When the �RECORDING PAUSE� key is pressed, the mode for opening of LINE MUTE is reached, and when it is pressed again, automatic recording and playback mode is reached and the following operation is performed.
01 ........ The head does not move up. 02 ........ The head does not move down. 03 ........ The tray does not close. 04 ........ The tray does not open.
7 Cancellation of test mode 1
Press the �STANDBY/ON� key or disconnect the AC power supply.
22
|
|
|
> |
|